If you have a problem with your Sony mirror (ILC interchangeable lens camera), you may receive an error message that you see a good chance to find the exact problem with the height of the camera.
Other times, the camera does not blink on the screen the error message. In these cases you need only the minimum information to refine the opportunity and then follow the following advice is given to solve Sony mirror cameras.
- Problems with the battery. When the battery becomes very hot during operation, the camera turns off automatically. To avoid this problem, avoid continuous shooting for more than 10 minutes. Even a break for a few seconds every few minutes should be enough to keep the temperature of the battery in check. Also, try your camera mirror Sony CDI direct sunlight.
- Problems with flash. Certain indigenous and local communities include Sony popups built-in flash, while others use an external flash require you to connect to a shoe. Make sure that you know what kind of flash you have. If you do not do it right the flash, regardless of whether it is safe and - that your fingers do not block - if you have a pop-up window. In addition, the camera flash mirror Sony is sometimes not in all shooting modes, such as anti-blur-motion work, Sweep Panorama, Handheld or in the evening to check the parameters of the camera, if you have problems using Flash.
- Poor quality images with flash. When you see dark spots in the picture with flash, with a filter or lens hood can cause this problem. When the overall image is too dark even if the flash is used, you are probably out of the reach of the flash.
- You can not record images. Most times when the camera images, it is because the memory card is full or a malfunction or because the interchangeable lens is not attached. Even if you use the Sony camera mirror in RAW mode, the camera takes a long time to save pictures, maybe make it so if the camera does not look the recording.
- The shutter speed and the aperture value of the Flash tries to take the picture., If you see icons on the camera's settings without a mirror, the display flashes when the shutter button is pressed halfway LCD, Sony can not CIT save the image with the current settings . You need to set the value of a parameter flashes Adjust Exposure to work properly.
- The LCD screen does not work. When small black or bright white dots appear constantly on the screen indicates a defective pixel on the camera's mirror-Sony LCD screen, it is not a problem with the log-camera function. These points are not in the picture, if it be viewed on a computer monitor or when printed. Keep all magnets away from the LCD screen and not directly press the LCD screen (unless your camera mirror ILC Sony LCD features a touch screen).
- The Sony DIL does not work well., That the battery is fully charged. When the camera is overheating, usually in direct sunlight for a long time or shoot continuously for a long time, could close the camera. Leave the camera simply idle until it cools. Also remove the battery and memory card for a few minutes and put them can solve the problem again.
No comments:
Post a Comment